The base of technical politics of The Closed Joint-stock Company "FINPROFILE" is orientation to the new customers, which had no earlier experience in operation with the modern automatic rolling equipment with the numerical control. Therefore, our equipment is created in order to guarantee maximum reliability and to be simultaneously simple enough in operation and service for our clients.

The lien of stable quality of different standard sizes of profiles made on the equipment of The Closed Joint-stock Company "FINPROFILE" is use for production modules control systems of equipment of well-known firms such as Siemens (Germany), Omron and Mitsubishi (Japan), which nomenclature allows to choose the components proceeding from concrete necessities of each separate client. The cases of control allow automating process of profiling and, depending on performance, are equipped with the interfacing of a different level of complexity. In this connection the systems suppose different levels of logical management - from most simple (monitoring of a condition of gauges, blocking of improper operations of human controller) up to ensuring high level of exactitude of an item (in addition weak start, increased exactitude of sections, diagnostics of condition).

The process of profiling lasts continuously to a short stop for transversal sections, thus the material of pre-form is given from a bunch of metal installed in the uncoiling device. The operation of profiling itself is carried out by working rolls distributed in order on shafts in roll mill stands. The complexity of the profiling instrument and amount of mill stands is determined by complexity of cross-section geometry of a produced profile. For section of the shaped item, guillotine electromechanical shears with figurate knifes or sawing assemblies with cuneiform knifes or with abrasive cutting disk are used depending on width and the complexities of a profile. The reception of final products of specific cut length is carried out by receiving table of proper size.

Designing new equipment The Closed Joint-stock Company "FINPROFILE" gives major attention to final adjustment and tests of the equipment before delivery at the factory in Pechenigy of the Kharkov oblast. Thus, the new equipment is installed after assembly in shop just in such a way as it would be installed at our customer and is tested in mode of actual production. The stage of careful debugging and testing before delivery allows to avoid financial losses after installation and commissioning of the equipment at production facilities of the customer. Besides, the careful tests allow minimizing terms of mastering of new equipment and operating costs.

The concept of forming of equipment park according to the principle "One line - one profile" ensures simultaneous executing of orders on different kinds of profiles that allows to reduce time on order execution and to increase volumes of production of the most claimed kinds of structures.